46
Revision date: 12.02.16
The monofilament tensioners are used to string lines of monofilament wire from one end header to the other. These
wire lines will serve as support, guiding tracks, and anti-billow agents for the shade/black-out material.
0($685( 0$5.02817/2&$7,216
Each monofilament line consists of one (1) 113650 wire tensioner, attached at one end, and one (1) 113694 slip-on
bracket attached at the other end (shown below). At one end wall, attach the 113650 tensioners. Starting in the center,
install one 113650 tensioner
below
the header, and one
above
. From there, attach a lower tensioner every 18". Attach
an upper tensioner every 36". Repeat for 113694 brackets at the opposite end header. See below for orientation
details.
Adjust as needed, but it is important to MIRROR locations exactly at each end
.
Arrows indicate wire
tensioner locations.
NOTE:
Additional end
framing removed for clarity.
36"
18"
IMPORTANT:
If necessary, adjust
wire mounts left or right as needed
to avoid obstructions such as end
wall columns, mid-rafter webbing
etc. Spacing is approximate
recommendation and not critical,
however,
remember to mirror
accordingly on the opposite end.
ATTENTION:
Dashed boxes
above indicate the locations along
WKHKHDGHUSUR¿OHZKHUHGULYH
components will be installed
.
Avoid
installing wire tensioners or brackets
in these locations.
Consult page 124
for drive component dimensions,
and install accordingly.
Monofilament Wire Mounts
ATTACH WIRE MOUNTS
Attach all upper and lower 113650 tensioners at one end header using FA4482 Tek screws. At the
other
end header,
attach one 113694 slip-on bracket every 18". Consult diagrams for orientation of hardware.
HORIZONTAL
BLACKOUT HEADER
WIRE TENSIONER
(113650)
INSID
E G
REE
NHO
USE
**NOTE:
WIRE TENSIONER BRACKETS SPACED EVERY 18" ON THE BOTTOM OF
FRONT ENDWALL HEADER (36” ON THE TOP) AND ARE TO BE PATTERNED AS SHOWN.
OUT
SIDE
OF
GRE
ENH
OUS
E
OUTS
IDE
OF G
REE
NHOUSE
HORIZONTAL
BLACKOUT HEADER
SLIP-ON WIRE
BRACKET
(113694)
INSI
DE
GREE
NHO
US
E
**NOTE:
SLIP-ON WIRE TENSIONERS ARE TO MIRROR THE WIRE TENSIONER
BRACKETS ON THE FRONT HEADER OF THE GREENHOUSE (SPACED EVERY 18").