47
Revision date: 12.02.16
Corner Cable Wire Mounts
Arrows indicate wire
tensioner locations.
NOTE:
Additional end
framing removed for clarity.
ATTENTION:
Bracket shown above will cause
interference with the end wall polycarbonate
cladding (installed later). If desired, the
FAG312B bolt can be used as a THROUGH
bolt to attach a 113650 wire tensioner in
this location as an alternative to avoid the
obstruction. Drill 5/16" through-holes if opting
to utilize through-bolt application. See diagram
to the right.
INSTALL CORNER CABLE WIRE MOUNTS
Each corner cable line consists of
WZRWHQVLRQHUEUDFNHWVRQHDWWD(81'(56,'(DWHDFK
end header
. At one end, attach the 112575 brackets in locations shown below using FAG312B bolts & FALB01B nuts.
Repeat for the other end. Verify wire tensioners are positioned on the inside edge of the tubes, as shown.
Install Corner Cable Wire Mounts an inch in from the corner to allow for access to crank wire tensioner.
Corner Cable
Wire Mount
Corner Cable
Wire Mount
Towards
INSIDE of
structure.
FAG312B
bolt &
FALF35B
lock nut.
VIEW FROM
BACKSIDE OF
END HEADER
HEADER
FAG312B bolt &
FALF35B lock nut.
113650
wire tensioner
Pre-drill 5/16"
through-holes.
Once all wire tensioners and wire brackets have been installed, continue by installing the front end wall fans and light
trap adaptor boxes.