Instruction Manual for the Delivery Table FREYA 3
Page 5
While rolling the table, do not hold the plastic covers of the base nor lying surface
frame, because it may damage the covers!
Labour in the horizontal position should take place on the shortened lying surface,
at least two steps from the max. extension, in order to avoid leakage of the
physiological fluids onto the base elements!
The central control panel enables the table movement after power supply failure
(only a few cycles, until the battery runs out). It is used for moving the table into a
particular position in emergency situations. However, do not overuse this function!
The table should be rolled by at least two persons.
Do not roll the loaded table (with a patient on) on inclined planes nor outdoors.
The table should be rolled at the min. height.
While rolling the table, the floor underneath must be free of obstacles!
During the table movement, avoid collisions!
Exercise caution while removing and mounting the permanent lying surface
moulding!
•
Application of excessive force may lead to damaging: permanent lying surface
mouldings, extended lying surface moulding or side mouldings of the lying surface
frame.
Washing and disinfection notes
•
Do not disinfect the device in disinfection chambers!
•
Do not use bleaching agents (containing active chlorine or oxygen), nor caustic
and corrosive agents!
•
As for plastic elements, you may not use any agents whose ingredients damage
these elements' net structure (organic solvents)!
•
Should the keyboards on the side rails or in the central control panel be spilled
over with water, some agents or other fluids, dry the keyboards as soon as
possible, and wipe their edges dry with a cloth!
•
Before disinfecting and cleaning, disconnect the power cord!
Failure to observe the requirements mentioned above, related to cleaning and
disinfecting,
shall render the medical device warranty null and void!