Instruction Manual for the Delivery Table FREYA 3
Page 11
2.
Transport and commissioning
2.1.
Transport
The product may be transported by all publicly available, covered means of transport. During
transport, the device should be secured against moisture and immobilised.
The device should be transported under the following conditions:
-
temperature:
–10°C to 60°C
-
relative humidity:
20% to 80%
While transporting, storing and unpacking the device, the temperature fluctuation may not exceed
10°C within an hour. The device may be unpacked onl y after reaching the room temperature where
the device is kept.
Having transported the device to the building where it will be mounted, leave it for at least 12 hours.
Only then can you proceed to commissioning.
It is acceptable to stack the device in layers acc. to the package marking. In case of absence of the
marking, the layer stacking is forbidden.
In the event of transporting the device under different conditions, especially in low temperatures, it is
necessary to consult with the manufacturer as regards the transport method and package type
ensuring safe transport.
2.2.
Unpacking and first start-up
NOTE!
If the device is mounted by the service team of FAMED
ś
YWIEC Sp. z o.o., then the
user is exempt from performing the activities described at this point.
The delivery table supplied by the manufacturer is pre-installed, in a box with these dimensions:
length:~ 69 in (1,750 mm) x width:~47 in (1,200 mm) x height:~43 in (1,100 mm) and weight: ~38 st
(240 kg).
So as to avoid damage of the device, unpack and mount it in the building.
So as to prepare the table for work after its delivery or transport:
-
carefully acquaint yourself with the instruction manual,
-
remove the package,
-
remove the materials protecting the table while in transport,
NOTE!
Packages may have the following signs:
-
reusable package
-
recyclable package
-
LDPE package
Handling of packaging waste should meet legal requirements specific to the
environmental protection, applicable where the product enters the market in the
packaging.
Packaging waste consists of recyclable materials that should be appropriately
segregated and submitted to the local segregated waste collection site in
accordance with requirements of the local legislation.
Reusable packaging should be returned to the medical device supplier.