Instruction Manual for the Delivery Table FREYA 3
Page 21
3.16. Installation and removal of the lying surface mouldings
In order to facilitate cleaning and disinfection, you can remove the mouldings of the permanent lying
surface (fig.1, item 19) or seat (fig.1, item 20), as well as the extended lying surface mouldings (fig. 1,
item 17).
The extended lying surface moulding removal is feasible once this section is completely extended.
CORRECT INSTALLATION INCORRECT INSTALLATION
EXTENDED LYING SURFACE MOULDINGS EXTENDED LYING SURFACE MOULDINGS
Fig. 5
NOTE!
Exercise caution as you remove and mount the mouldings.
Particular attention should be paid to ensure that the extended lying surface
moulding is installed correctly (see fig. 5). Otherwise, the moulding and sliding
strips of the lying surface might be damaged.
Application of excessive force might result in damaging the mouldings.
3.17. Infusion rod
The infusion rod is embedded in bushings located in the permanent lying surface frame, near the
headboard. The height of the infusion rod can be adjusted. In order to do so, unscrew the knob on the
rod body. Set the desired height, holding the body with one hand, and pulling the post with the other.
Lock it with the knob again.
NOTE!
Maximum permissible load of all the infusion rod hooks: up to 0.5 st (3 kg).
3.18. Mattress
The delivery table comes complete with three mattresses, that is:
1. Extended lying surface mattress
2. Seat and backrest section mattress.
3. Small mattress for the newborn, located in the extended lying surface moulding.
Turn the small labour mattress so that the protrusion is oriented upwards. The protrusion is
to be placed at the low board side. After the birth of a child, at the postnatal period, turn the
small mattress and cover it with the extended lying surface mattress.