Fagor 8055 EN, Programming Manual

Page: 357 / 482

Programming manual
CNC 8055
CNC 8055i
HIGH-LEVEL LANGUAGE
PR
OGRAMMING
13.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·357·
Va
riabl
es
(^) When the machine has a general handwheel and individual handwheels (associated with an
axis), it indicates which handwheel has priority when both are turned at the same time.
0 = The individual handwheel has priority. The relevant axis ignores the pulses from the
general handwheel, the rest of the axes don’t.
1 =The general handwheel has priority. It ignored the pulses from the individual handwheel.
(a, b, c) Indicate the axis to be moved and the selected multiplying factor.
If several axes are selected, the following order of priority is applied: X, Y, Z, U, V, W, A, B, C.
If there are more than one bit set to "1" for an axis, the least significant bit will be considered. Thus:
The HBE handwheel has priority. That is, regardless of the mode selected at the CNC switch
(continuous or incremental JOG, handwheel), HBEVAR is set to other than "0", the CNC goes into
handwheel mode.
It shows the selected axis in reverse video and the multiplying factor selected by the PLC. When
the HBEVAR variable is set to "0", it shows the mode selected by the switch again.
Read-and-write variables
MASLAN
It must be used when the path-handwheel or the path-jog is selected. Indicates the angle of the linear
path.
MASCFI MASCSE
They must be used when the path-handwheel or the path-jog is selected. On circular paths (arcs),
they indicate the center coordinates.
c b a
0 0 0 The value indicated at the front panel or keyboard switch.
0 0 1 x1 factor
0 1 0 x10 factor
1 0 0 x100 factor
c b a
1 1 1 x1 factor
1 1 0 x10 factor