Fagor 8055 EN, Programming Manual, Page: 291 / 482

Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·291·
PROBE 1. Too
l leng
th
cal
ibratin
g ca
nne
d cycl
e
[ D5.5 ] Distance from the tool shaft to the probing point
It sets the radius or distance referred to the tool shaft being probed.
If not defined, probing is carried out on the tool tip.
[ S±5.5 ] Speed and turning direction of the tool
To probe with the spindle running, the tool must be turning in the opposite direction to the cutting
direction.
• When set to 0, probing is carried out with the spindle stopped.
• When set with a positive value, the spindle starts in M3.
• When set with a negative value, the spindle starts in M4.
[ C ] Behavior when exceeding the amount of wear allowed
Only if "L" has been set to other than zero.
C = 0 It interrupts the execution for the user to select another tool.
C = 1 The cycle replaces the tool with another one of the same family.
If not programmed, the cycle will assume the C0 value.
[ N ] Number of edges to measure
When set to zero, it only takes one measurement. If not programmed, the cycle will assume the N0
value.
To measure each cutting edge when the spindle has feedback and s.m.p. M19TYPE (P43) =1.
[ X U Y V Z W ] Probe position
Optional parameters. See "Programming format" on page 289.