Fagor 8055 EN, Programming Manual

Page: 106 / 482

·106·
Programming manual
CNC 8055
CNC 8055i
6.
PATH
CONTROL
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
Tan
gen
ti
al control (G4
5
)
4. If the joint of sections requires a new orientation of the tangential axis, the following takes place:
·1· Ends the current section.
·2· Orients the tangential axis with respect to the next section.
·3· Resumes the execution.
When working in round corner (G05), the tool orientation is not maintained at the corners since
it begins before ending the current section.
It is recommended to work in square corner (G07). However, to work in round corner (G05),
function G36 (automatic radius blend) should be used in order to also maintain tool orientation
at the corners.
4. To cancel this function, program G45 alone (without defining the axis).
Even when the tangential axis takes the same orientation by programming 90° or -270°, the turning
direction in a direction change depends on the programmed value.