Fagor 8055 EN, Programming Manual

Page: 331 / 482

Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·331·
PROB
E 11. Circular
part
center
ing canned cycle.
12.13.1 Basic operation
1. Approach movement (according to the value given in Q), first in the axes of the plane and then
in the longitudinal axis, to the position of the first probing (only if X or Y or Z has been
programmed).
2. Probing movement (at the feedrate given in H), in the given axis and direction until touching the
part.
3. Withdrawal (distance given in E) for the measuring probing movement.
4. Probing movement (at the feedrate given in F) until touching the same side again.
5. Rapid up movement in Z (distance given in D) up to the Safety Z coordinate.
6. Movement (according to the value given in Q) up to the opposite approach point considering the
diameter of the part.
7. Probing movement (at the feedrate given in H) to go down to the probing Z coordinate. If it touches
the part, the probe goes back up to the safety Z position and moves the distance indicated by
parameter B (in the same direction) until clearing the part.
8. Probing movement (at the feedrate given in H) until touching the part.
9. Withdrawal (distance given in E) for the measuring probing movement.
10. Probing movement (at the feedrate given in F) until touching the part again. This calculates one
of the coordinates of the real center of the part.
11. Rapid up movement to the safety Z coordinate.
12. Movement (according to the value given in Q) up to the approach point of the remaining axis
considering the calculated center coordinate.
13. Probing movement (at the feedrate given in H) to go down to the probing Z coordinate. If it
touches the part, the probe goes back up to the safety Z position and moves the distance
indicated by parameter B (in the same direction) until clearing the part.
14. Probing movement (at the feedrate given in H) until touching the part.
15. Withdrawal (distance given in E) for the measuring probing movement.
16. Probing movement (at the feedrate given in F) until touching the part again.
17. Rapid up movement to the safety Z coordinate.
18. If part surface measuring has not been programmed, it goes on to point 23; and if it has been
programmed, movement (according to the value given in Q) up to the center of the part.
19. Probing movement (at the feedrate given in H) until touching the surface of the part.
20. Withdrawal (distance given in E) for the measuring probing movement.
21. Probing movement (at the feedrate given in F) until touching the surface of the part again. This
measures the coordinate of the part surface and it is saved in parameter P297.
22. Rapid up movement to the safety Z coordinate.
23. Movement (according to the value given in Q) up to the opposite approach point considering
the diameter of the part.
24. Probing movement (at the feedrate given in H) to go down to the probing Z coordinate. If it
touches the part, the probe goes back up to the safety Z position and moves the distance
indicated by parameter B (in the same direction) until clearing the part.
25. Probing movement (at the feedrate given in H) until touching the part.
26. Withdrawal (distance given in E) for the measuring probing movement.
27. Probing movement (at the feedrate given in F) until touching the part again. This calculates the
real center of the circular part and it is saved in parameters P298 and P299.
28. Rapid up movement to the safety Z coordinate. Rapid movement up to the calculated center.