Fagor 8055 EN, Programming Manual

Page: 167 / 482

Programming manual
CNC 8055
CNC 8055i
CANN
ED
CYCLES
9.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·167·
G82.
D
ri
lli
ng canne
d cycl
e with dwel
l
Options after tool withdrawal
Once the tool has been retracted, the user will have the following options:
• Finish the hole.
• Go to the next hole.
• Go into tool inspection.
After this, the CNC will display the following message:
"To end the cycle, press START to skip to the next SKIPCYCL".
Finish the hole:
To finish the hole, press the [START] key.
It goes down in G0 with spindle running to 1 mm before the coordinate where the hole stopped. From
then on, it continues at the F and S programmed in the cycle.
Go to the next hole:
To go to the next hole, activate the PLC mark SKIPCYCL.
The CNC will display the following message:
"Press [START] to continue".
Pressing the [START] key, the CNC considers the cycle to be finished and continues with the next
block.
Go into tool inspection
If you don't wish to finish the hole nor go to the next hole, it is possible to go into a standard tool
inspection.
In this case, a block must be selected and a standard repositioning must be done before resuming
the execution of the program.
After inspecting the tool, once repositioning is done, the following choices will be offered:
• Resume the interrupted cycle.
• Skip the interrupted cycle and resume at the next block.