Fagor 8055 EN, Programming Manual

Page: 300 / 482

·300·
Programming manual
CNC 8055
CNC 8055i
12.
PROBING
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
PROBE 2.
Probe ca
libration canned cycle.
12.4.1 Basic operation
1. Approach movement.
Probe's rapid movement (G00) from the cycle calling point to the center of the hole.
The approaching movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis.
2. Probing movement.
This movement consists of:
·1· Probe movement along the ordinate axis at the feedrate indicated by (H) until the probe signal
is received.
The maximum distance to be traveled in the probing movement is "B+(J/2)", if, after travelling
that distance, the CNC does not receive the probe signal, it will display the corresponding
error code and stop the movement of the axes.
·2· Return of the probe in rapid (G00) the distance indicated in (E).
·3· Probe movement along the ordinate axis at the feedrate indicated by (F) until the probe signal
is received.
3. Withdrawal movement.
Movement of the probe in rapid (G00) from the point where it probed to the real center of the hole.
4. Second probing movement.
Same as above.
5. Withdrawal movement.
Movement of the probe in rapid (G00) from the point where it probed to the real center of the
hole along the ordinate axis.
6. Third probing movement.
Same as above.
7. Withdrawal movement.
Movement of the probe in rapid (G00) from the point where it probed to the real center of the hole.
8. Fourth probing movement.
Same as above.
9. Withdrawal movement.
This movement consists of:
·1· Movement of the probe in rapid (G00) from the point where it probed to the real center of
the hole.