Fagor 8055 EN, Programming Manual

Page: 175 / 482

Programming manual
CNC 8055
CNC 8055i
CANN
ED
CYCLES
9.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·175·
G84. Ta
ppin
g
ca
nne
d cycl
e
Tool withdrawal
While machining, the CNC lets withdraw the tool to the starting plane stopping the spindle when
the tool reaches the starting plane.
Activating PLC mark RETRACYC (M5065) stops the main axis and the spindle, the tool is withdrawn
changing the direction of the axis and spindle while keeping the machining F and S values. This
withdrawal will be to the starting plane.
The stopping and starting sequence of the spindle and the axis when tapping keeps the same
synchronism and dwells as during the execution of the canned cycle.
Options after tool withdrawal
Once the tool has been retracted, the user will have the following options:
• Finish the hole.
• Go to the next hole.
• Go into tool inspection.
After this, the CNC will display the following message:
"To end the cycle, press START to skip to the next SKIPCYCL".
Finish the hole:
To finish the hole, press the [START] key.
The hole is repeated from the starting plane under the same F and S conditions without stopping
at the point where it stopped.
Go to the next hole:
To go to the next hole, activate the PLC mark SKIPCYCL.
The CNC will display the following message:
"Press [START] to continue".
Pressing the [START] key, the CNC considers the cycle to be finished and continues with the next
block.
; Tool selection.
T1
M6
; Starting point.
G0 G90 X0 Y0 Z0
; Canned cycle definition. Three machining operations are carried out.
G84 G99 G91 X50 Y50 Z-98 I-22 K150 F350 S500 N3
; Positioning and canned cycle
G98 G90 G00 X500 Y500
; Cancels the canned cycle.
G80
; Positioning.
G90 X0 Y0
; End of program.
M30