Fagor 8055 EN, Programming Manual

Page: 327 / 482

Programming manual
CNC 8055
CNC 8055i
PROBING
12.
·M· & ·EN· M
ODELS
S
OFT
: V02.2
X
·327·
PROBE 10
. Rectang
ula
r pa
rt centerin
g ca
nne
d cycl
e
[ B5.5 ] Approach distance
Part approaching distance in each probing movement. If not programmed or programmed as 0, it
assumes the approach distance value from the probe position to the part.
[ D±5.5 ] Probe's up distance
Distance for the probe to go up in Z for its movements over the part. If not programmed or
programmed with a 0 value, it generates the corresponding error message.
[ E±5.5 ] Withdrawal distance
Distance the probe retracts after finding the part, to make the measurement. If not programmed or
programmed with a 0 value, it generates the corresponding error message.
[ H5 ] Probing feedrate for part search
If not programmed or programmed with a 0 value, it generates the corresponding error message.
[ F5 ] Probe's measuring feedrate
If not programmed or programmed with a 0 value, it generates the corresponding error message.
[ Q5] Probe feedrate when going to the approach points
Probe feedrate when going to the approach points. If not programmed, it assumes rapid traverse
(G0).