Serial Communication, cont’d
MLC 52 Series MediaLink Controller • Serial Communication
5-30
1
ON
2 3 4
Removing commands from an IR 452 button
You can remove either one command from an IR 452 button, or all the button’s
commands at once.
Similar to the MLC 52 front panel buttons, removing commands one at a
time is allowed only in descending order. For example, you must remove
command 4 before removing commands 3, 2, and 1.
1
.
Select the button from which you want to remove commands. The button
becomes light gray.
2
.
If you want to remove only one command, select the Cmd radio button for
the memory block containing the command to be removed.
If you want to remove all the commands, you do not need to select a Cmd
radio button.
3
.
Under Remove IR/232 Codes in the Actions field, click one of the following
buttons:
•
One Command
— Removes the command only from the selected
memory block
•
All Commands in Button
— Removes all the commands from all the
memory blocks on the button.
A confirmation prompt window appears.
4
.
Click OK. The specified command(s) are removed from the selected button.
On the screen, the red or green field is removed from around the Cmd radio
button(s).
Performing IR Learning via software
The MLC 52 can “learn” commands from your projector’s remote control in order
to control the projector or devices such as VCRs or DVD players. Using IR
Learning, you can program command codes to each of the button’s four memory
blocks. You can also use IR Learning to program the IR 452 button functions on
the MLC. (The MLC cannot be mounted in the wall or furniture when you are
doing this.)
Follow these steps to initiate IR Learning via the Configuration program:
1.
Set configuration DIP switch #1 on the MLC rear panel to
On (up).
2.
Open the MLC 52 configuration software.
3
.
On the MLC 52 or the IR 452 diagram on the Controller (MLC) Config. tab,
select the button for which you want the MLC to learn IR codes.
4.
Select the Cmd radio button for the memory block where you want the
command to be stored.
5.
Click Learn IR to Button.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203