5-17
MLC 52 Series MediaLink Controller • Serial Communication
Driver Selection window showing that memory block 1 (Cmd 1)
contains an RS-232 (green) command
•
On the MLC diagram, the circle representing the memory block that you
just programmed on the selected button appears
green
.
MLC diagram showing an RS-232 command programmed on the PC
button
5
.
If you want to assign another command to the same button, select the next
Cmd radio button, then repeat steps
3
and
4
.
For each button, you can perform this procedure up to four times, until the
button’s four memory blocks are all assigned.
For RS-232, you can
not
mix driver functions from different devices on the
same button. Only one RS-232 driver can be used at a time.
6
.
When finished programming commands to the button, click Close to close
the Driver Selection window.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203