5-29
MLC 52 Series MediaLink Controller • Serial Communication
7
.
When finished programming commands to the button, click Close to close
the Driver Selection window.
On the Controller Config. (MLC) tab, the following is displayed:
•
At the top of the tab, the radio button for the command memory block
you just programmed is surrounded by a red field (for an IR command)
or a green field (for an RS-232 command). In the example above, an IR
command was programmed in memory block 1 (Cmd 1).
•
A dot appears on the button to indicate that it contains commands. If
the button’s first programmed memory block contains an IR command,
the dot is red. If the button’s first memory block contains an RS-232
command, the dot is green. (In the same example, the MUTE ON
button now contains an IR command.)
IR 452 diagram showing an IR command programmed on the
MUTE ON button
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203