Installation, cont’d
MLC 52 Series MediaLink Controller • Installation
2-4
Screws to remove
from the MLC faceplate
Replacing the faceplate and button labels
The MLC’s faceplate and the backlit button labels can be replaced. You can replace
the provided plastic faceplate with an optional metal one — the MLM 52 1GWP
one-gang metal faceplate (part #70-528-02 or -03) or the MLM 52 VC two-gang
metal faceplate (part # 70-538-02 or -03), both of which are available in black or
white. You may also wish to replace your plastic faceplate with one of a different
color (two plastic faceplates are provided, one black and one white).
Replacing the faceplate
1.
Hold the MLC face down. Use an Extron
Tweeker or a small Philips screwdriver to
remove the three attachment screws
(marked
a
in the diagram at right) from the
back of the MLC, and keep them to replace
later.
CAUTION
If installing a metal faceplate, do not
remove the screws from the front of the
faceplate.
2.
Lift the MLC off the faceplate.
3.
Place the MLC onto the new faceplate, aligning
the MLC’s buttons with the openings
in the new faceplate and the three screw holes
in the MLC with the faceplate standoffs.
4.
Replace the three screws removed in step
1
, and hand tighten them.
Refer to the MLM 52 1GWP and/or the MLM 52 VC user’s guides for further
information on faceplates for the MLC 52.
Faceplate
Standoff
MLC 52
Installing the MLC onto a new faceplate
Replacing button labels
The button caps are pre-labeled for your convenience by default. However, you
can change them with the included button labels.
The button assembly consists of a clear lens cap, the button label, and a white
diffuser. (See the diagram on the next page.) Remove the button assembly from
the MLC 52 as follows:
1
1
1
2
3
4
E
ON
2 3 4
Tx
IR OUT
GND
IR IN
GND
+ 12V
1
1
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203