Operation, cont’d
MLC 52 Series MediaLink Controller • Operation
3-12
Powering the Projector/display On and Off
The Display ON and OFF buttons on the MLC 52 front panel are used to turn the
projector or other display on and off.
Powering on
Press and release the MLC 52’s ON button to turn the display device’s power on.
The MLC sends an RS-232 or IR power-on command to the projector, and the ON
button blinks for 4 seconds, then remains steadily lit.
Powering off
To turn the projector/display off, press the OFF button. The OFF button blinks for
4 seconds, then remains steadily lit.
(A 2-second hold feature, requiring you to press and hold the OFF button for 2
seconds in order to turn off the display device, helps prevent accidental powering
off of the projector or display. This feature can be disabled and enabled through the
configuration software. See
Using the Misc. Options tab
, in chapter 5,
Serial
Communications
, for further information.)
Selecting Inputs
The four buttons below the Projector ON and OFF buttons on the MLC 52 front
panel can configured to select inputs on the projector. The PC and VIDEO buttons
have been preconfigured to select inputs—the desktop or laptop computer (PC); the
VCR or DVD (VIDEO).
Using IR Learning, IR data transfer, or the Windows-based control software, you
can reconfigure these buttons and/or add commands to them to select other inputs
if desired. The two volume (VOL) buttons can be configured to select inputs as
well, if you do not need them to control projector volume. Up to four commands
can be programmed on any button. See
Using the MLC 52 Configuration Program
, in
chapter 5,
Serial Communication
, for information on configuring MLC buttons.
MLC 52
DISPLAY
ON
PC
VIDEO
OFF
VOL
VOL
Input Selection
buttons
Input selection buttons on the MLC 52 front panel
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203