5-15
MLC 52 Series MediaLink Controller • Serial Communication
Configuring buttons using RS-232 drivers
After you have selected and loaded an RS-232 driver, you are ready to assign
commands from the selected driver onto the MLC buttons. Follow these steps to
configure the MLC’s buttons with RS-232 commands on the Controller (MLC)
Config. tab:
1
.
On the MLC 52 diagram on the left, click on the button to which you want
to add a command. In the following example, the PC button was selected.
PC button selected on Controller (MLC) Config. tab
After you select an RS-232 driver, by default the projector power ON and
OFF buttons and the VOL UP and VOL DWN buttons are preconfigured
with the appropriate commands from the driver. If the VOL UP and
VOL DWN buttons will not be used for volume control, remove the
commands from them. See
Removing commands from a button
, later in
this chapter.
When you select the button, the following occurs on the screen:
•
The selected button turns yellow, surrounded by a square black border.
The Button field in the upper-left corner of the tab shows the name of
the button that was selected.
•
Radio buttons for the selected button’s four command memory blocks
(Cmd 1 through Cmd 4) are displayed at the top of the tab. The radio
button for the memory block you are currently programming is selected.
•
Switch Mode and Actions buttons are displayed in a column down the
center of the tab.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203