Special Applications, cont’d
MLC 52 Series MediaLink Controller • Special Applications
4-10
b
.
Within 5 seconds (while the VIDEO button on the MLC 52 is blinking),
press the Video button on the projector’s remote control. The MLC has
learned command “A” for video.
When a command has been successfully learned, the IR Learning LEDs on
the MLC rear panel flash in rapid progression from the top to the bottom, then
back to the top.
3
.
Program the input selection command “A” from the S-video input selection
button on the projector’s remote control into memory block #2 of the
MLC 52’s VIDEO button as follows:
a
.
Press the VIDEO button on the MLC front panel. The button begins to
blink, indicating that the MLC is now ready to learn command “A” from
the projector remote control’s S-video button. On the rear panel, the
second LED up from the bottom should be flashing.
b
.
Within 5 seconds (while the VIDEO or blank button on the MLC 52 is
blinking), press the S-video button on the projector’s remote control. The
MLC has learned command “A” for S-video.
4
.
Program the input selection command “B” from the Video input selection
button on the projector’s remote control into memory block #3 of the
MLC 52’s VIDEO button as follows:
a
.
Press the VIDEO button on the MLC front panel. The button begins to
blink, indicating that the MLC is now ready to learn command “B” from
the projector remote control’s Video button. On the rear panel, the third
LED up from the bottom should be flashing.
b
.
Within 5 seconds (while the VIDEO or blank button on the MLC 52 is
blinking), press the Video button on the projector’s remote control. The
MLC has learned command “B” for Video.
5
.
Program the input selection command “B” from the S-video input selection
button on the projector’s hand-held remote control into memory block #4 of
the MLC 52’s VIDEO button as follows:
a
.
Press the VIDEO button on the MLC front panel. The button begins to
blink, indicating that the MLC is now ready to learn command “B” from
the projector remote control’s S-video button. On the rear panel, the
fourth LED up from the bottom should be flashing.
b
.
Within 5 seconds (while the VIDEO or blank button on the MLC 52 is
blinking), press the S-video button on the projector’s remote control. The
MLC has learned command “B” for S-video.
6
.
When finished programming the MLC 52 buttons, return configuration
switch #1 to its Off (down) position. Test the system.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203