Extreme Networks ExtremeWare XOS 11.3, Manual

Page: 65 / 698

Using Telnet
ExtremeWare XOS 11.3 Concepts Guide
65
If you need the switch's MAC address to configure your BOOTP or DHCP server, you can find it on the
rear label of the switch. Note that all VLANs configured to use BOOTP or DHCP use the same MAC
address to get their IP address, so you cannot configure the BOOTP or DHCP server to assign multiple
specific IP addresses to a switch depending solely on the MAC address.
Manually Configuring the IP Settings
If you are using IP without a BOOTP server, you must enter the IP parameters for the switch in order
for the SNMP Network Manager or Telnet software to communicate with the device. To assign IP
parameters to the switch, you must perform the following tasks:
●
Log in to the switch with administrator privileges using the console interface.
●
Assign an IP address and subnet mask to a VLAN.
The switch comes configured with a default VLAN named default . To use Telnet or an SNMP
Network Manager, you must have at least one VLAN on the switch, and that VLAN must be
assigned an IP address and subnet mask. IP addresses are always assigned to each VLAN. The
switch can be assigned multiple IP addresses (one for each VLAN).
NOTE
For information on creating and configuring VLANs, see Chapter 9 .
To manually configure the IP settings:
1 Connect a terminal or workstation running terminal emulation software to the console port, as
detailed in
“Using the Console Interface” on page 60 .
2 At your terminal, press [Return] one or more times until you see the login prompt.
3 At the login prompt, enter your user name and password. Note that they are both case-sensitive.
Ensure that you have entered a user name and password with administrator privileges.
■
If you are logging in for the first time, use the default user name admin to log in with
administrator privileges. For example:
login: admin
Administrator capabilities enable you to access all switch functions. The default user names have
no passwords assigned.
■
If you have been assigned a user name and password with administrator privileges, enter them at
the login prompt.
4 At the password prompt, enter the password and press [Return].
When you have successfully logged in to the switch, the command line prompt displays the name of
the switch.
5 Assign an IP address and subnetwork mask for the default VLAN by using the following command:
configure vlan <vlan_name> ipaddress [<ipaddress> {<ipNetmask>} | ipv6-link-local
| {eui64} <ipv6_address_mask>]
For example:
configure vlan default ipaddress 123.45.67.8 255.255.255.0
Your changes take effect immediately.