Extreme Networks ExtremeWare XOS 11.3, Manual

Page: 238 / 698

Virtual LANs
ExtremeWare XOS 11.3 Concepts Guide
238
configure vman vman_tunnel_1 add port 3:1 untagged
configure vman vman_tunnel_1 add port 3:2 tagged
enable dot1p examination inner-tag port 3:2
Displaying VMAN Configurations
You can display the VMAN configuration and associated EAPS domains by issuing the
show vman
command. You can also display VMAN information, as well as all the VLANs, by issuing the
show
port information detail
display.
To display information on all VMANs, use the following command:
show vman
The following is sample output from the
show vman
command:
-------------------------------------------------------------------------------
Name VID Protocol Addr Flags Proto Ports Virtual
Active router
/Total
-------------------------------------------------------------------------------
peggy 100 10.10.255.3 /24 f-----m-------- ANY 0 /0 VR-Defaul
t
-------------------------------------------------------------------------------
Flags : (C) EAPS Control vlan, (E) ESRP Enabled, (f) IP Forwarding Enabled,
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback
Enabled, (m) IPmc Forwarding Enabled,
(n) IP Multinetting Enabled, (N) Network LogIn vlan,
(o) OSPF Enabled, (p) PIM Enabled,
(P) EAPS protected vlan, (r) RIP Enabled, (T) Member of STP Domain,
(v) VRRP Enabled
Total number of Vlan(s) : 6
To display information on a specific VMAN, use the following command
show vman <vlan_name>
The following is sample output from the
show vman test
command on a modular switch:
VLAN Interface with name test created by user
Tagging:Untagged (Internal tag 4090)
Priority: 802.1P Priority 0
Virtual router: VR-Default
Primary IP : 10.10.255.3/24
IPv6: NONE
STPD: None
Protocol: Match all unfiltered protocols
Loopback: Disable
NetLogin: Enabled
Rate Shape: Disable
QosProfile: QP1
Ports: 2. (Number of active ports=2)
Flags: (*) Active, (!) Disabled
(g) Load Sharing port
Untag: *3:1
Tag: *3:2