Extreme Networks ExtremeWare XOS 11.3, Manual

Page: 160 / 698

Link Layer Discovery Protocol
ExtremeWare XOS 11.3 Concepts Guide
160
You advertise the maximum frame size available on the LLDP-enabled port using the maximum frame
size TLV. To advertise the maximum frame size, issue the following command:
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-specific
dot3 max-frame-size
Unconfiguring LLDP
To unconfigure LLD, issue the following command:
unconfigure lldp
This command only returns the LLDP timers to default values; LLDP remains enabled, and all the
configured TLVs are still advertised.
To leave LLDP enabled, but reset the advertised TLVs to the five default TLVs, issue the following
command, and specify the affected ports:
unconfigure lldp port [all | <port_list>]
Displaying LLDP Settings
The system displays information on the LLDP status and statistical counters of the ports, as well as
about the LLDP advertisements received and stored by the system. You can display information on the
LLDP port configuration and on the LLDP neighbors detected on the port.
NOTE
Refer to ExtremeWare XOS Command Reference Guide for complete information on displaying LLDP settings.
Displaying LLDP Port Configuration Information
Use the
show lldp
command to display LLDP port configuration information. To display detailed
LLDP information, add the
detailed
option.
The following is sample output of the
show lldp
command:
# show lldp
LLDP transmit interval : 30 seconds
LLDP transmit hold multiplier : 4 (used TTL = 120 seconds)
LLDP transmit delay : 2 seconds
LLDP SNMP notification interval : 5 seconds
LLDP reinitialize delay : 2 seconds