Extreme Networks ExtremeWare 7.2e, Installation And User Manual

Page: 167 / 344

Using Routing Access Profiles
ExtremeWare 7.2e Installation and User Guide 167
Figure 27: OSPF access policy example
To configure the switch labeled Internet, the commands would be as follows:
create access-profile okinternet ipaddress
configure access-profile okinternet mode permit
configure access-profile okinternet add 192.1.1.0/24
configure ospf asbr-filter okinternet
Routing Access Profiles for PIM
Because PIM leverages the unicast routing capability that is already present in the switch, the access
policy capabilities are, by nature, different. If you are using the PIM protocol for routing IP multicast
traffic, you can configure the switch to use an access profile to determine:
Trusted Neighbor —Use an access profile to determine trusted PIM router neighbors for the VLAN on
the switch running PIM. To configure a trusted neighbor policy, use the following command:
configure pim vlan [<vlan name> | all] trusted-gateway [<access profile> | none]
Example
Using PIM, the unicast access profiles can be used to restrict multicast traffic. In this example, a network
similar to the example used in the previous RIP example is also running PIM. The network
administrator wants to disallow Internet access for multicast traffic to users on the VLAN Engsvrs. This
is accomplished by preventing the learning of routes that originate from the switch labeled Internet by
way of PIM on the switch labeled Engsvrs.
ES4K014
Internet
Backbone (OSPF)
area 0.0.0.0
Sales
area 0.0.0.2
Engsvrs
area 0.0.0.1
10.0.0.10 / 24
10.0.0.11 / 24
10.1.1.1 / 24 10.2.1.1 / 24
10.0.0.12 / 24
Switch being
configured
Engsvrs
Sales
Internet