Evoqua WALLACE & TIERNAN DEPOLOX 5 E 700 P Series, Instruction Manual

Page: 30 / 82

30
WT.050.810.040.DE.IM.0519
Installation
DEPOLOX
®
5 E flow cell
4.
4.4.1 Sequence
Perform the mechanical installation according to the following check list.
4.4.2 Installing the modules with top-hat rail
Proceed as follows, referring to the dimension drawings on Chapter 4.4.4
“Dimension drawings”:
1 Secure the top-hat rail to a solid wall using the supplied dowels and
screws. Screws and dowels for fixing to a solid wall are included in
the scope of delivery.
Please note
If the device is to be installed on a suitable lightweight wall, use the rele -
vant mounting fixtures (not included in the scope of delivery).
2 Hook the electronics module onto the top-hat rail so that it is flush at
the right.
3 Fasten the electronics module to the solid wall at the bottom by the
holders using dowels and screws.
4 Hook the DEPOLOX
®
5 E flow cell onto the mounting rail on the left
next to electronics module.
5 Fasten the DEPOLOX
®
5 E flow cell to the solid wall at the bottom by
the holders using dowels and screws.
Ser. No. Task Reference to chapter Completed
1 Installation of the modules
• With top-hat rail or without top-hat rail
4.4.2
2 Taking off the housing cover 4.4.5
3 Connecting the sample water inlet
• With hose connection or with rigid pipes
4.4.6
4 Connecting the sample water outlet 4.4.8
5 Installing the fine filter (with membrane sensors
only)
4.4.9
6 Removing the felt ring 4.4.10
7 Removing and replacing transport caps 4.4.11
8 Filling the electrode cleaning sand 4.4.12
9 Connecting the three-electrode measuring cell
and connecting sensors with DFMe electronics
module
4.4.13
10 Fitting the sensors (optional) 4.4.14
11 Installing calibration aids 4.4.15
12 Fitting the enclosure cover 4.4.5