DEPOLOX
®
5 E flow cell
Installation
4.
27
4.2
Transport and storage
Transport
The DEPOLOX
®
5 E flow cell is supplied in standard packaging. During
transport, the packaged system must be handled carefully and should
not be exposed to wet weather or moisture.
Check that the transport packaging is undamaged. In the event of dam
-
age, please inform the transport company immediately, as your rights to
compensation will otherwise be lost.
If a component is damaged, please contact your affiliate immediately.
Keep the packaging until the DEPOLOX
®
5 E flow cell has been correctly
installed and taken into operation.
Storage
Store the electronics module, the DEPOLOX
®
5 E flow cell and the sen
-
sors in a dry condition without any residual water in a dry place that is not
exposed to the weather. Storage temperature, see chapter 3.5 “Techni
4.3
Ambient conditions
Please note
Correct and safe operation can only be guaranteed if the requirements
for the ambient conditions are met. All applicable national and local reg
-
ulations must be observed!
4.3.1
Installation site
The following points must be taken into account when installing
DEPOLOX
®
5 E flow cell:
• The DEPOLOX
®
5 E flow cell must be protected from moisture, rain,
frost, heat and direct sunlight and must not be installed outdoors.
• Do not use the DEPOLOX
®
5 E flow cell in environments where
there are flammable gases, fumes or dust or conductive dust.
• Do not subject the DEPOLOX
®
5 E flow cell to strong shocks or
vibrations.
• The air in the room should be non-condensing.
Summary of Contents for WALLACE & TIERNAN DEPOLOX 5 E 700 P Series
