DEPOLOX
®
5 E flow cell
Installation
4.
31
4.4.3
Installation variant without top-hat rail
Instead of hooking the DEPOLOX
®
5 E flow cell and the 700 P electron
-
ics module or 700 M electronics module onto the top-hat rail, they can
also be hooked onto suitable tallow-drop screws by the top holding clips.
Please note
The dimensions for the drilling pattern can be found on the back of the
plastic housing.
Proceed as follows:
1
Affix the supplied tallow-drop screws and dowels to the solid wall.
Tallow-drop screws and dowels for fixing to a solid wall are included
in the scope of delivery.
Please note
If the device is to be installed on a suitable lightweight wall, use the rele
-
vant mounting fixtures (not included in the scope of delivery).
2
Hook electronics module into the tallow-drop screws.
3
Fasten the electronics module to the solid wall at the bottom by the
holders using dowels and screws.
4
Hook DEPOLOX
®
5 E flow cell into the tallow-drop screws.
5
Fasten the DEPOLOX
®
5 E flow cell to the solid wall at the bottom by
the holders using dowels and screws.
Please note
If 700 P electronics module or 700 M electronics module and DE
-
POLOX
®
5 E flow cell are installed in different locations, you must use
CAN bus extension cable (optional); see chapter 6.3.2 “CAN bus exten
sion cable for connection to DFMe electronics module”. This must not be
longer than 1000 m.
Summary of Contents for WALLACE & TIERNAN DEPOLOX 5 E 700 P Series
