42
WT.050.810.040.DE.IM.0519
Installation
DEPOLOX
®
5 E flow cell
4.
4.4.11
Removing and replacing transport caps
Please note
Before initial commissioning of the DEPOLOX
®
5 E, the transport cap of
the electrolyte tank must be removed and replaced with the enclosed op
-
erating cap.
Non-pressurized version
For the non-pressurized version, proceed as follows:
1
Take out the yellow protection cap of the electrolyte tank.
2
Replace the transport cap with the enclosed operating cap.
Image 8 Detail: cell body cover, non-pressurized version
A Protection cap (yellow)
B Stopper (with white venting rod)
Pressurized version
Attention!
During operation, the cap must always be in place.
For the pressurized version, proceed as follows:
1
Extract the knurled nut.
2
Remove the long transport cap from the electrolyte tank and replace
with the short operating cap (enclosed).
3
Fit the knurled nut.
Image 9 Detail: cell body cover, pressurized version
A Transport cap (long)
B Stopper (short)
A
B
A
B
Summary of Contents for WALLACE & TIERNAN DEPOLOX 5 E 700 P Series
