EverFocus Flex1.0, User Manual, Page: 70 / 123

Automatically Enroll Cards to Controllers
The first way to apply cards to controllers is to automatically apply them when the cards
are enrolled into the system. To do that, check the “Auto Add” button in the card
attribute toolbar. Then register cards. All cards registered will be automatically applied to
all the controllers in the controller list.
Note that the cards will be applied to all the controllers in the list when registering cards
if “Auto Add” is checked. So if you want to only apply the cards to some of the
controllers, you can either remove the cards later, or you can manually apply the cards
to controllers, which is described in the next subsection.
Fig. 8.7: Check the “Auto Add” button to apply cards to controllers automatically
Manually Apply Cards to Controllers
Fig. 8.8: Card access attributes setting
To manually apply cards to a controller, follow the steps below:
1. Select the card to be enrolled from the cardholder list.
The access attributes are listed in the card access attributes area, as shown in Fig.
8.8. The figure shows that the system has 3 controllers: number 0001, 0002 and
0003. Card access attributes are empty, indicating that the selected card is not
registered to any controller.
2. In the controller list, check the controller(s) that the card will be applied to. For
example, check two controllers 0001 and 0002 as in Figure 8.9.
63