Hardware Mounting
26
We.R System
9.2
Mounting/Dismounting a Motion Detector
(PIR)
1.
Peel off the mounting tape’s protective covering to mount the Motion
Detector (spherical lens pointed down) on a wall, about 220 cm above the
floor and at least 10 cm below the ceiling.
2.
Place the Motion Detector in a suitable location that does not directly face
sunlight or other strong light sources.
For optimal surveillance, place the Motion Detector in a position where
it will detect movement inside the home.
Do not install the Motion Detector opposite a window.
3.
For detaching the device from the wall (in case of battery replacement or
any other maintenance activity), press the white lock at the bottom of the
device and slide the device downwards simultaneously.
4.
The minimum detection period between 2 detections is 2.5 minutes. Within
this interval, no new detections will activate the device.
9.3
PIR and IPD Operational Modes
The We.R system has 2 operation modes for PIR and IPD devices:
Walk Test Mode
: A test mode which occurs after the device powers up
(insert a new battery) or after adding a new device (learning process).
The objective is to test the system functionality.
This mode lasts 10-minutes and during this time, the device will be
sending an event to the Control Panel after detecting an even.
Normal Operation Mode
: After the end of the Walk test mode (i.e. after 10
minutes), enter Normal Operation mode. This mode saves battery power.
In this mode, the device will sleep for 2.5 minutes after a detection
event. This means that the device will not transmit events to the
Control Panel.
If during sleep mode, a second detection occurs within the sleep time,
the sleep timer will reset to 2.5 minutes.
This process will repeat until there is no detection for an entire 2.5
minutes.
9.4
Mounting/Dismounting a Window or Door
Sensor
Each window / door sensor has 2 components:
A Magnetic Detector
A smaller Magnet
