Hardware Mounting
42
We.R System
Symptom
Solution
3.
A best practice before the “Add Device” procedure,
remove any static electricity from a device battery.
Remove static electricity from a device as follows:
Motion and Camera Devices: Remove the batteries
from the device and shake the device for a few
seconds
Key Fob: Remove the battery, and then press any
button on the Key Fob
Siren: Remove the batteries and place the small
tongue on the battery cover in the slit at the bottom
right of the battery container for a few seconds
Remove Static Electricity from the Siren
Alternatively, remove the battery cover and then
return it to its original location, over the batter
compartment.
D.2
Magnet Detector (MGL)
Symptom
Symptom
The magnet (detector
and LEDs) does not
work or is warm
Check the following:
1.
Verify the battery is inserted correctly with the "+" and
"-" polarity observed
2.
Check for any damage to the device that may have
occurred during handling (i.e. dropping the device)
3.
Verify that the alignment dots on both parts of the
detector are aligned to each other during mounting
