Network Camera User Manual
73
Anonymous Access to the FTP Server (in which case the user name and
password won’t be required.):
Check the
Anonymous
checkbox to enable the
anonymous access to the FTP server.
Note:
The anonymous access function must be supported by the FTP server.
6.
Click
Save
to save the settings.
7.2.3
Configuring Email Settings
Purpose:
The system can be configured to send an Email notification to all designated receivers
if an alarm event is detected, e.g., motion detection event, video loss, video tampering,
etc.
Before you start:
Please configure the DNS Server settings under
Configuration > Network > Basic
Settings > TCP/IP
before using the Email function.
Steps:
1.
Enter the
TCP/IP Settings (
Configuration > Network > Basic Settings >
TCP/IP
)
to set the IPv4 Address, IPv4 Subnet Mask, IPv4 Default Gateway and
the Preferred DNS Server.
Note:
Please refer to
Section 7.1.1 Configuring TCP/IP Settings
for detailed
information.
2.
Enter the Email Settings interface:
Configuration
>
Network
>
Advanced
Settings
>
.
3.
Configure the following settings:
Sender:
The name of the email sender.
Sender’s Address:
The email address of the sender.
SMTP Server:
IP address or host name (e.g., smtp.263xmail.com) of the SMTP
Server.
SMTP Port:
The SMTP port. The default TCP/IP port for SMTP is 25 (not
secured). And the SSL SMTP port is 465.
Summary of Contents for MicroView MVIB-01IR-E
