ERNITEC MicroView MVIB-01IR-E, User Manual

Page: 77 / 172

Network Camera User Manual
76
Wireless Dial
Purpose:
Data stream of audio, video and image can be transferred via 3G/4G wireless network.
Note: The wireless dial function may not be supported by some camera models.
Steps:
1.
Click Wireless Dial tab to enter the Wireless Dial configuration interface:
Configuration > Network > Advanced Settings > Wireless Dial
2.
Check the checkbox to enable the wireless dial settings.
3.
Configure the dial parameters.
1)
Select the dial mode from the drop-down list. Auto and Manual are selectable.
If Auto is selected, you can set the arming schedule for dialing; If Manual is
selected, you can set the offline time and manual dialing parameters.
2)
Set the access number, user name, password, APN, MTU and verification
protocol. You can also leave these parameters blank, and the device will adopt
the default settings for dialing after other parameters are configured.
3)
Select the network mode from the drop-down list. Auto, 3G and 4G are
selectable. If Auto is selected, the network selection priority comes as: 4G >
3G > Wired Network.
4)
Input the offline time if Manual is selected as the dial mode.
5)
Input the UIM Number (Mobile Phone Number).
6)
Click the Edit button to set the arming schedule if Auto is selected as the dial
mode.
7)
vii.Click Save to save the settings.
4.
View the dial status.
1)
Click the Refresh button to view the dial status including real-time mode, UIM
status, signal strength, etc.
2)
If Manual is selected as the dial mode, you can also manually connect /
disconnect the wireless network.
5.
5.Set the white list. The mobile phone number on the white list can receive the