Epson Stylus Photo 950, Service Manual

Page: 19 / 191

EPSON Stylus PHOTO 950 Revision A
PRODUCT DESCRIPTION Printer Function 19
1.3 Printer Function
1.3.1 Operator controls
The control panel is shown in the figure below.
Figure 1-6. Operator controls
1.3.2 Operate switch
†
Ink switch
†
Roll Paper switch
†
Paper switch
†
Power switch
1.3.3 Indicators
†
Power : Green
†
Paper Error : Red
†
Ink Error : Red
1.3.4 Panel Functions
NOTE: (*1) Tear OFF
→
Cut by Cutter
→
Tear Off Return
As for the Tear Off execute, and, Tear Off isn't done again right
after loading paper.
NOTE: (*2) Pushing for 3 seconds.
NOTE: (*3) According to the content of 1BH of EEPROM, one of following
actions is carried out.
NOTE: (*4) Not described in the User's manual.
NOTE: (*5) Not described in the User's manual.
Refer to 1.3.5 "Special settings mode (*1)" page 20
Power switch
Paper switch
Ink switch
Roll Paper switch
Table 1-5. Normal Panel Functions
Switch Function
Paper
• Loads or Ejects the Paper
• Return from Error
Roll Paper
No Cutter
• Tear Off feed and return
• Load or Eject (Back Out feed) Roll paper
(*2)
Use Cutter
• Tear Off (*1)
• Load or Eject (Back Out feed) Roll paper
(*2)
Ink
• Start the Ink Cartridge change sequence
• Cleaning
(*2)
Table 1-6. Panel Function with Power on
Switch Functions
Paper
Starts status printings (*3)
Roll Paper
Change code pages / Select IEEE1284.4 mode
for parallel I/F
(*4)
Paper
+
Roll Paper
Enters the special settings mode
(*5)
Table 1-7. The Content of 1BH of EEPROM
[bit7][bit6] Action
00(H)
Print firmware version, ink counter, selected code page and
nozzle check pattern
11(H)
01(H)
Start hex-dump printing
10(H)
Start self test printing