Epson Stylus Photo 950, Service Manual

Page: 111 / 191

EPSON Stylus PHOTO 950 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 111
4. Remove the Extension Spring which is securing the left side of the Linear Scale
from the top of the Main Frame (Left).
5. Disengage the right side of the Linear Scale which is secured to the Mechanism
Frame.
6. Disengage the left side of the Linear Scale which is secured to the Mechanism
Frame.
7. Pull out the Linear Scale from the left side.
C A U T I O N C A U T I O N C A U T I O N
„
When installing the carriage guide, install it so that it does not
get bent and so that there is enough room for the carriage to
pass.
Figure 4-36. CR Guide Plate Installation
„
When installing the carriage guide plate, insert the two dowels
on the printer mechanism into the two mounting holes.
„
When installing the carriage guide plate, the screws should be
installed in the order shown in Figure 4-36.
C A U T I O N
When replacing or re-installing the Printhead, make sure that the
CR Guide Plate is correctly installed first.
If this is not done, the end of the Printhead may contact the surface
of the Paper Guide, which could cause damage to the Printhead
during installation.
C A U T I O N
When removing the Extension Spring, handle the spring carefully
and do not pull it more than necessary, otherwise the spring may
become stretched.
CR Guide Plate
Main Frame
No force
should be
applied
Should not be
too narrow
Profile
C H E C K
P O I N T
The Extension Spring will not fall down even when it is removed
from the Main Frame (Left).
C A U T I O N
If the Linear Scale is pulled out from the right side, the Extension
Spring may be damaged, so always pull it out from the left side.
Figure 4-37. Linear Scale Removal
C A U T I O N C A U T I O N C A U T I O N
„
When installing the Extension Spring to the Liner Scale, be
careful not to twist the end of the Spring.
„
The linear scale should be installed so that the notched part on
the left end is facing upward.
Extention Spring
Linear Scale
Hooks
Hook