Epson Stylus Photo 950, Service Manual

Page: 157 / 191

EPSON Stylus PHOTO 950 Revision A
ADJUSTMENT Adjustment 157
5.2.12 First Dot Position Adjustment
This section describes how to adjust the first dot position adjustment. Basically, this
adjustment is not required to your usual repair activity. But sometimes, a specific user
requires you to do the fine-adjustment for the first dot position.
NOTE: The adjustable range is from -72 mm to +72 mm for Stylus PHOTO 950
printers.
NOTE: This adjustment can change the left and right margins in single steps
(+/- 0.0088 mm).
1. Setup the adjustment program. Main screen (Figure 5-3) appears.
(Refer to Section 5.2.1.)
2. Select "Adjustment" and then "First dot position".
3. Main screen changes as below.
Figure 5-48. First Dot Position Adjustment Initial Screen
4. Check the current Left and Right Margins between printed line and paper top edge
using a measure. And decide your target adjust value. (ex. -1mm or +2mm.)
5. Use the UP/DOWN keys and the left and right buttons in the program screen to
select the desired value, and then click "OK".
NOTE: If you click on the UP/DOWN arrow buttons the display value increases
or decreases. You can also use the left and right arrow button below this
to change the value to the maximum or minimum value or to change it in
steps of +/- 4.
6. Following screen appears.
Figure 5-49. Adjustment Value Selection Screen
7. Check the printing whether your target line prints or not.
8. If you judge the re-adjustment is necessary, repeat step 5 to step 7 until you judge
the adjustment has completed.