Epson EPL-N4000, Service Manual

Page: 224 / 306

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 210
4.2.61 Inverter Clutches
(See Appendix “Exit Drive Assembly” on page -280)
4.2.61.1 Removal
1. Remove the Exit Drive Assembly.(“Exit Drive Assembly” on
page -201)
2. Remove the four screws securing the Drive Support to the Inverter
Bracket, and lift the Support off of the Bracket.
3. Disconnect P/J 218 and P/J 219, and free the wire harness from the
harness clips.
4. Slide the CCW Gear off of the CCW Clutch.
5. Slide the CW Gear off of the CW Clutch.
6. Lift the CCW Clutch off of the bearing, and remove the Clutch.
7. Lift the CW Clutch off of the bearing, and remove the Clutch.
4.2.61.2 Installation
1. Reinstall the two bearings into the cutouts in the Inverter Bracket.
2. Position the CW Clutch so the gear faces away from the Bracket,
and insert the shaft at the rear of the Clutch into the bearing. Make
sure the notch in the Clutch hooks onto the tab on the Bracket.
(Refer to the figure for correct positioning).
3. Position the CCW Clutch so the gear faces away from the Bracket,
and insert the shaft at the rear of the Clutch into the bearing. Make
sure the notch in the Clutch hooks onto the tab on the Bracket.
(Refer to the figure for correct positioning).
4. Reinstall the CW Gear onto the CW Clutch shaft.
5. Reinstall the CCW Gear on to the CCW Clutch shaft.
6. Route the wire harness under the harness clips and reconnect P/J
218 and P/J 219.
7. Carefully reinstall the Drive Support onto the Inverter Bracket,
making sure the Clutch shafts fit into the bearings in the Support.
8. Use four screws to secure the Drive Support to the Inverter Bracket.
9. Reinstall the Exit Drive Assembly. (“Exit Drive Assembly” on
page -201)
Figure 4-76. Removal of Inverter Clutches