Epson EPL-N4000, Service Manual

Page: 167 / 306

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 153
4.2.13 Tray1 Retard Assembly
(See “Retard and Take Away-Tray 1” on page -260)
4.2.13.1 Removal
1. Remove Tray 1 Take Away Roll Assembly. (“Tray1 Take Away Roll
Assembly” on page -147)
2. Remove the Left Middle Cover. (“L/H Low Cover Assembly” on
page -178)
3. Remove the screw securing the Feed In Chute to the Assembly, and
slide the Chute to the front of the Assembly to remove it.
4. Remove the plastic Feed Chute (“Retard and Take Away-Tray 1” on
page -260) from the Take Away Roll.
5. Unhook the spring from the Retard Support.
6. Remove Tray 1 Support Assembly Spring. (“Support Assembly
Spring” on page -152)
7. Remove the screw securing the Gear Stopper (“Retard and Take
Away-Tray 1” on page -260) to the Assembly, and move the Stopper
out of the way.
8. Remove the E ring securing Gear 22/20 (“Retard and Take Away-
Tray 1” on page -260) to the shaft and remove the Gear.
9. Remove the plastic bearing securing the Take Away Roll Shaft to
the front of the Retard Frame, and remove the Retard Assembly and
Take Away Roll.
10. Remove the E rings and Gears attached to the rear of the Take
Away Roll Shaft.
11. Remove the Center Bearing on the Take Away Roll Shaft, and slide
the Roll out of the Retard Support.
Figure 4-22. Disassembly of Tray1 Retard Assembly
4.2.13.2 Installation
1. Reinstall the Take Away Roll Shaft onto the Retard Support.
2. Reinstall the Center Bearing onto the Take Away Roll Shaft, and
secure the Shaft to the Support.
3. Reinstall the Gears (“Retard and Take Away-Tray 1” on page -260)
and E rings to the rear of the Take Away Roll Shaft.
4. Reinstall the Retard Assembly and Take Away Roll back into the
Retard Frame.
5. Reinstall the plastic bearing into the hole at the front of the Retard
Frame.
6. Reinstall Gear 22/20 to the rear of the shaft, and use an E ring to
secure the Gear.