Epson EPL-N4000, Service Manual

Page: 182 / 306

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 168
4.2.25.2 Installation
1. Reinstall the MSI Side Guide, making sure the two latch tabs at the
bottom of the Guide fit through the cutout in the Upper Cover.
2. Slide the Side Guide all the way to the right (toward the MSI Tray
Spring).
3. Hold the Side Guide in place while you press the two holes in the
Size Sensor onto the two latch tabs. Press hard enough so the Size
Sensor locks into place.
4. Make sure the spring-loaded arm of the Sensor is under the molded
track.
5. Slide the Sensor Assembly to the left to make sure it moves
smoothly and the spring-loaded arm lowers as you move the Sensor
to the left, and raises when you move the Sensor to the right.
6. Route the Sensor wire harness along the molded channel and
through the cutout on the right side of the Upper Cover.
7. Reconnect J107.
8. Reinstall the MSI Tray, with the arrow side facing down.
9. Slide the three tabs on the upper edge of the Lower Cover into the
three cutouts in Upper Cover, and press the Lower Cover onto the
Upper Cover.
10. Press at the five latch locations to make sure the latches have
locked the Lower Cover in place.
11. Use two screws to secure the Lower Cover to the Upper Cover.
12. Reinstall the MSI Feeder Assembly. (“MSI Feeder Assembly
(Manual Feeder)” on page -164)
C H E C K
P O I N T
Be sure to engage the actuator of MSI Sensor
and the hole of MSI Size Link.
Be sure that actuator also moves when you
mode the Link.