Epson EPL-N4000, Service Manual

Page: 195 / 306

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 181
4.2.35 Left Lower Cover Pinch Roll Assembly
(See “Tray 2 Frame and Left Cover” on page -270)
4.2.35.1 Removal
1. Remove the Left Lower Cover Assembly. (“Left Lower Cover
Assembly” on page -180)
2. Remove the three screws securing the Pinch Roll Bracket to the
Assembly, and remove the Bracket.
3. Unhook the two Pinch Roll Springs and lift the Pinch Roll out of the
Bracket.
4. Remove the two Center Bearings and the two End Bearings from
the Roll.
4.2.35.2 Installation
1. Reinstall an End Bearing to each end of the Pinch Roll.
2. Reinstall the Pinch Roll onto the Bracket.
Make sure that the lip of each Bearing is trapped behind the tabs in
the Bracket.
3. Hook one end of each Pinch Roll Spring into a spring hole in one
side of the Bracket.
4. Bring the Springs over the Pinch Roll Shaft and hook the other end
of each Spring into the spring hole on the opposite side of the
Bracket.
5. Slide a Center Bearing under each Pinch Roll Spring, as shown in
the figure.
6. Reinstall the Bracket onto the Left Lower Cover Assembly, and use
three screws to secure it to the Assembly.
7. Reinstall the Left Lower Cover Assembly.(“Left Lower Cover
Assembly” on page -180)
Figure 4-50. Removal of Left Lower Cover Pinch Roll Assembly