Epson EPL-N4000, Service Manual

Page: 159 / 306

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 145
4.2.8 Tray 1 Feed Clutch
(See “Tray Interface -Tray 1” on page -258)
4.2.8.1 Removal
1. Remove the Rear Cover. (“Rear Cover Assembly” on page -140)
2. Open the Duplex Unit.
3. Open the Left Upper Cover.
4. Disconnect J202 from the Tray 1 Feed Clutch.
5. Remove the E ring that is securing the Feed Clutch to the shaft.
6. Slide the Feed Clutch away from the printer frame, then rotate the
Clutch until you have enough clearance from the Support Spring to
slide the Clutch completely off of the shaft.
Figure 4-15. Removal of Tray 1 Feed Clutch
4.2.8.2 Installation
1. Position the Feed Clutch over the end of the Feed Shaft.
2. Reposition the Feed Clutch so it fits the key notch on the shaft and
you can feel the Clutch slide onto the shaft, and press the Clutch
onto the shaft until the Clutch P/J clears the Support Spring.
3. Rotate the Clutch until the slot in the Clutch lines up with the key on
the frame.
4. Press the Clutch onto the shaft until it stops, and make sure the key
on the frame is in the slot in the Clutch.
5. Use an E ring to secure the Clutch to the shaft.
6. Reconnect J202 to the Feed Clutch.
7. Reinstall the Rear Cover. (See “Rear Cover Assembly” on
page -140)