Epson EPL-N4000, Service Manual

Page: 165 / 306

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 151
4.2.11.2 Installation
1. Hold down the Stopper Link while you insert the end of the Feed
Shaft into the opening in the rear of the printer frame.
2. Slide the Bearing into the Bearing cutout (refer to the figure).
3. When both the Bearing is in place and the end of the Feed Shaft is
through the opening in the rear of the frame, release the Stopper
Link.
4. The Nudger Shaft should rest on top of the Stopper Link, and the
Link should secure the Feeder Assembly in place on the frame.
5. Make sure the Paper Level Actuator tab on the Feeder is positioned
in the center of the arms of the Paper Level Sensor.
6. Slide the Feed Bearing onto the Feed Shaft and press the Bearing
into the cutout in the frame.
7. Reinstall the Feed Gear onto the Feed Shaft, and use an E ring to
secure it to the Shaft.
8. Reinstall Tray 1 Feed Clutch along with the Feed Gear and Bearing.
(“Tray 1 Feed Clutch” on page -145)
9. Reinstall the Front Chute. (“Tray 1&2 Front Chute Assemblies” on
page -155)
10. Reinstall the Rear Cover. (“Rear Cover Assembly” on page -140)
11. Reinstall Tray 1.
Figure 4-20. Removal of Tray1 Feed Assembly