Epson EPL-N4000, Service Manual

Page: 40 / 306

EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 26
1.4.1.1 Status Sheet
Engine Status Sheet is prepared and Jam Counter is not printed.
Hardware configuration
Mounted memory for installed memory
The memory size obtained by subtracting the program code size from
the mounted memory is stated for Available Memory. The following
legends indicate the fact that options are fitted.
RAM DIMM: Added to Installed Memory, Available memory
Type-B I/F: “AUX” is added to “Installed Interface”.
Large Capacity Paper Unit: “Lower Cassette 3, Lower Cassette 4,
Lower Cassette 5” is added to “Other
Options”.
ENV Tray: “ENV Tray” is added to “Other Options”.
Face-up Tray: When Face-up Enable of Setup Menu = On, “Face-
up Tray” is added to “Other Options”.
Duplex Unit: “Duplex Unit” is added to “Other Options”.
Multibin: “Multibin” is added to “Other Options”.
Finisher: “Finisher Stapler” is added to “Other Options”.
HDD: “Hard Disk XGB” is added to “Other Options”.
NLSP Font ROM: The option product name is added to “Other
Options”.
Font/Macro ROM: The option product name is added to “Other
Options”.
When Adobe PS 3 kit is installed: “Adobe PS 3 kit Menu, Error
Sheet” is added to “Default Settings” “Adobe PostScript3” is added
to “Installed Emulation” “Version of Adobe PS 3 kit” is added to
“Firmware Revision”.
NOTE: For EPL-N4000, Finisher and HDD cannot be installed.
1.4.2 Panel Setting Mode
Here explains panel setting mode which sets various function of the
printer.
1.4.2.1 One Touch Setting Mode
By pressing Select Type(ALT) switch on the control panel, the printer
enters to the one-touch setting mode1, then goes to the one-touch set-
ting mode 2. Setting items at each setting mode are mentioned below.
Table 1-27. One touch setting modes
Mode/Switch Setting Menu Setting Item Setting Value Enter
One touch
setting mode1 Paper source Page size Minification Orientation
One touch
setting mode2 Printer mode Copies MP tray size Duplex