Epson EPL-N4000, Service Manual

Page: 215 / 306

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 201
4.2.52 Exit Drive Assembly
(See “Exit Drive Assembly” on page -280)
4.2.52.1 Removal
1. Remove the Offset Unit Assembly.(“Offset/Exit Assembly” on
page -200)
2. Remove the three screws securing the Exit Drive Assembly to the
Offset Unit Assembly.
3. Pull the Exit Drive Assembly straight out and away from the Offset
Unit.
Figure 4-67. Removal of Exit Drive Assembly
4.2.52.2 Installation
1. Align the Exit Drive Assembly with the Offset Unit Assembly so the
white drive gear and shaft fit through the corresponding opening in
the Exit Drive Assembly.
2. Press the Exit Drive Assembly onto the Offset Unit, slightly
repositioning the Assembly so the positioning pin on the upper right
side of the Offset Unit fits through the corresponding hole in the Exit
Drive Assembly. Make sure you do not trap any wire harnesses
between the Exit Drive Assembly and the Offset Unit Assembly.
3. Use three screws to secure the Exit Drive Assembly to the Offset
Unit Assembly.
4. Reinstall the Offset Unit Assembly. (“Offset/Exit Assembly” on
page -200)