Epson EPL-N4000, Service Manual

Page: 202 / 306

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 188
4.2.41 Registration Chute Assembly
(See “Registration” on page -271)
4.2.41.1 Removal
1. Remove the Left Upper Cover Assembly. (“Left Upper Cover
Assembly” on page -185)
2. Remove the Registration Clutch.(“Registration Clutch” on
page -184)
3. Remove the screw securing the Inner Cover to the printer frame,
and remove the Inner Cover.
4. Remove the EP Cartridge. (“EP Cartridge (Toner Cartridge)” on
page -192)
5. Remove the screw securing the Magnet Plate to the printer frame,
and remove the Plate.
6. Remove the two screws (under the Magnet Plate) securing the front
of the Registration Chute to the printer frame.
7. Remove the two screws (under the Registration Clutch) securing
the rear of the Registration Chute to the printer frame, and remove
the Chute.
8. Disconnect P/J103 from the Registration Sensor.
4.2.41.2 Installation
1. Reconnect P/J103 to the Registration Sensor.
2. Reinstall the Registration Chute Assembly into the printer
frame.Make sure the mylar strip is on the outside of the Chute.
3. Align the four screw holes (two at each end) in the Registration
Chute with the four screw holes in the printer frame.
4. Use two screws to secure the Chute to the front of the frame, and
use two screws to secure the Chute to the rear of the frame.
5. Reinstall the Magnet Plate to the printer frame, and use one screw
to secure the Plate.
6. Reinstall the Inner Cover to the frame, and use one screw to secure
the Cover.
7. Reinstall the Left Upper Cover Assembly.
8. Reinstall the Registration Clutch. (“Left Upper Cover Assembly” on
page -185)
9. Reinstall the EP Cartridge. (“EP Cartridge (Toner Cartridge)” on
page -192)
Figure 4-56. Removal of Registration Chute Assembly