Auto Setup With the Access Point
If the access point such as a wireless router supports the WPS, security settings can be made
automatically.
WPS-PBC
Note:
WPS-PBC is a method to authenticate and register devices required for wireless configuration, by
pressing the button provided on the access point via wireless routers, and then performing WPS-PBC
setting on the operator panel. This setting is available only when the access point supports WPS.
1. On the operator panel, press the
(
Menu
) button.
2. Select
Admin Menu
, and then press the button.
3. Select
Network
, and then press the button.
4. Select
WPS Setup
, and then press the button.
5. Select
Push Button Control
, and then press the button.
6. Select
Start
, and then press the button.
7. Press and hold the WPS button on the access point.
8. Wait a few minutes until the printer restarts to establish the wireless network.
9. Print a System Settings page from the operator panel.
See “Printing and Checking the System Settings Page” on page 34.
10. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
Note:
When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
AL-M200 Series User’s Guide
Printer Connection and Software Installation
87
