7. Press the
Start
key.
The document is scanned, and then the fax is sent.
Note:
❏
To stop the transmission, press the
Stop/Reset
key. A message appears, requesting confirmation
to cancel the setting. Select
YES
, and then press the
Select
key.
❏
If
FAX TX
in
ADMIN. MANAGEMENT
/
PASSWORD SETTING
/
FULL FUNC. NO.
has been
restricted, type in the number specified for
FULL FUNC. NO.
after pressing the
Start
key.
❏
If the fax could not be sent (for example, because the line was busy), the automatic redial function
will try sending the transmission again.
If the fax could not be sent with the automatic redial function, a TX Result Report can be printed.
For details, refer to “TX RESULT REPORT” on page 69.
❏
If you want to cancel a scanned document queued for transmission or a fax waiting to be
redialed, select
CANCEL RESERV.
from the menu. For details, refer to “Canceling a Queued
❏
If memory is nearly full, scanning of the document is stopped and a message appears, allowing
you to select whether to start the transmission or cancel that transmission job. If the selection is
made to cancel the job, the pages of the document that have been scanned for that job are deleted.
If the selection is made to begin the transmission, transmission begins. After the scanned pages
have been sent, scanning of the document starts again.
Sending a Fax Using the Original Glass
1. Press the
Fax
key to enter Fax mode.
Note:
If the initial mode (
UTILITY
-
MACHINE SETTING
-
INITIAL MODE
) is set to
FAX
, this step can be
skipped.
2. Remove all documents from the ADF.
Note:
If you are using the original glass to scan, do not load any documents into the ADF.
3. Lift to open the ADF cover.
Epson AcuLaser CX37DNF Facsimile User’s Guide
Sending Faxes
24
