Laser 100W15OO
Manual
Adjustment
4.1 ADJUSTMENT
This section describes the adjustment procedure for the
and
1000/1500.
This adjustment must be performed after every servicing operation, especially when any
component or part is replaced.
4.1.1 Print Position Adjustment
You can adjust the vertical print position on a sheet of paper by turning the image synchronizing
volume control on the engine controller board
After the engine driver board
is
replaced, be sure to adjust the print position following the procedure below.
1. Set LANGUAGE to ENGLISH in
Level 2.
2. Run a FEATURE PRINT in
Level 2.
Perform the following procedure if the
registration gap between the leading edge of paper and the printing of a horizontal line is not
the following value:
PRINT page for
1000:
2.5
FEATURE PRINT page for
2.5 mm (1.41 0.10 inch)
Note:
The FEATURE
contains the model name on
side. Check the
model name on the
PRINT page before adjusting.
position of the
horizontal line is
for the
1000 than for the
1500.
24.7 2.5
(1.37+/-
a
35.8
%25
(1.41
Leading Edge
/
I
I
I
FEATURE
Figure 4-1. Print Position Adjustment
3.
Tumtheprinter power off.
UPPer
open
upper
remove
one screw securing the
panel.
Figure 4-2. Opening the Upper Unit, Upper Cover and
Removing 1 Screw
Rev.
