Adjustment
Laser 1000/1500 Service Manual
5.
6.
7.
9.
While holding the control panel, adjust the image synchronizing adjustment volume
the engine controller board
so that the gap for the print position of the horizontal
line (vertical print position) becomes 32.4 mm (1.27 inch) for the
1000 or
33.5 mm (1.32 inch) for the
1500.
●
Turn
clockwise to decrease the gap for the print position of the horizontal line.
●
Turn
counterclockwise to increase the gap.
Turn on the printer.
Run a FEATURE PRINT in
Level 2 again to check the print position.
Repeat steps 3 to 7 above
the print position is 32.4
(1.27 inch) or 33.5 mm
(1.32 inch).
Reattach the control panel, securing it with the one screw, close the upper cover, and close the
upper unit.
Figure 4-3. Holding the Control Panel Figure 4-4. Closing the
Cover
and Adjusting
and the Upper
4-2
Rev.