Disassembly and Assembly
Laser 1000/1500
Manual
3.2 DISASSEMBLY AND ASSEMBLY
This section describes and illustrates the procedures for removing and disassembling the
components of the EPL-5000/5200 and ActionLaser 1000/1500. Cleaning is described in Chapter 6.
The assembly procedures are not described, except for special notes where necessary, because
assembly can be accomplished by performing disassembly in reverse.
3.2.1 Removal of the Video Controller Section
The control section is comprised of the video controller board (the
MAIN board), the
upgrade board
ROM-B board), and the control panel board.
3.2.1.1 Video Controller Board
MAIN)
Removal
Before you remove the video controller board, make sure that you remove any optional
cards or cartridges. Otherwise, you may damage the
or card connectors on the
board as well as the cartridge or card itself.
Turn the printer so that its left side faces you.
2. Remove the 2
screws
x 14) securing the interface card cover; then
off the cover.
3.
Remove the 3
screws
x 6) that secure the metal bracket on the left side of the
printer.
X
1 4 )
Card Cover
Figure 3-1.
the Interface
X
6 )
Figure 3-2. Removing the 3 Screws
4.
Pull the tab on the bottom of the bracket to release the video controller board, as shown below.
5. Grasp the board with both hands and pull it out of its slot.
Tab
Figure 3-3. Pulling the Tab
Figure 3-4. Removing the Video
Controller Board
3-4
Rev. A
